progdvb.com

as the title says.

Try install and select ac3filter for AC3.

ps: Please send me picture of info.

I'm using ffdshow and the ffdshow audio decoder runs but in the info section there's no codec info so theres no ac3 to decode.

Please try ac3filter also (if audio is AC3)

AC3Filter dont work

codepage problems... Please record me 4-5 minutes sample in Service->Pid records->All TS from this transponder.

File is big but you can put on my ftp.

Its 1.12GB it should take about 32 minutes if it uploads flat out.

Thanks for interesting sample. I am not know this type of codepage(compression?) of EPG but try fix this in one of next version.

About sound - I am recommend install and select divx aac for aac.

Crypted?
http://www.technovia.co.uk/2010/06/dumb ... es-do.html

If I enable an analog capture device the program just closes and wont start till the settings are reset I would love to use the component input on my BGT3650 so far I have not found a way.

Divx dont work.

I assume ur working on a solution for the audio issue?

I check again. This is LATM AAC audio format. Now all AAC codecs support LATM, but divx is good. I on my PC your sample playback without problems (exclude encrypted EPG)

I just remembered T2 uses HE-AAC the only codec I can find is coreaac but its not x64.

I installed the x86 progdvb and it cant connect the coreaac decoder.

The x86 version cant change the frequency the tuner is set to and all frequencies return the channels on the last frequency it was set to.

Is it possible to let a graph editor program to connect to the progdvb graph?

Impossible. In am not test coreaac. But divx good for all channels and free.

But divx wont work for me its not x64 and the x86 progdvb wont work properly with my hardware, and why is it not possible to connect to the graph with a graph editor to help me troubleshoot?