Page 1 of 1
Can't add channels
Posted: Mon Mar 12, 2007 6:12 pm
by wildeye
I get a signal but scan transponder and channel search show nothing.
Any ideas?
Posted: Mon Mar 12, 2007 6:19 pm
by SiLencer
No DVB card ? ? ?
Driver?
Codec(s) used?
Settings / options? Like timeshift related f.e.?
How about the original software or other DVB applications?
L / Q, bird(s) /position(s)
...
Recordings also showing symptoms? If so, on which player(s)?
Checked those in PVAStrumento, f.e.? Error messages then?
Full relevant details, please.
Magic crystal ball out for polishing ATM, sorry...
Posted: Mon Mar 12, 2007 6:28 pm
by wildeye
SiLencer wrote:No DVB card ? ? ?
Driver?
Codec(s) used?
Settings / options? Like timeshift related f.e.?
How about the original software or other DVB applications?
L / Q, bird(s) /position(s)
...
Recordings also showing symptoms? If so, on which player(s)?
Checked those in PVAStrumento, f.e.? Error messages then?
Full relevant details, please.
Magic crystal ball out for polishing ATM, sorry...
I have a skystar2 card.
SkyNet.sys 4.3.0
SkyDll,Sky2pcui,a/v filter, 4.4.0
Sat AMC3
ProgDVd ver 4.82.1
I'm using a setup top box to check all my transponder setting.
Posted: Mon Mar 12, 2007 6:34 pm
by SiLencer
Use only original driver from technisat ..best is 4.40 atm ...
About up to date transponder lists :
viewtopic.php?t=27
copy to \progdvb\transponders
choose it in diseqC settings and make a scan...
Posted: Mon Mar 12, 2007 7:13 pm
by wildeye
SiLencer wrote:Use only original driver from technisat ..best is 4.40 atm ...
About up to date transponder lists :
viewtopic.php?t=27
copy to \progdvb\transponders
choose it in diseqC settings and make a scan...
Yep, that did the trick the 4.3 driver caused the problem thanx!
Posted: Fri May 11, 2007 9:18 pm
by shapiro
wildeye wrote:SiLencer wrote:Use only original driver from technisat ..best is 4.40 atm ...
About up to date transponder lists :
viewtopic.php?t=27
copy to \progdvb\transponders
choose it in diseqC settings and make a scan...
Yep, that did the trick the 4.3 driver caused the problem thanx!
Thank'a lot, I had the same problem of no scanning and it solves with the 4.40 Skynet.sys driver. The distribution was in 4.3 driver.
