Hi all,
need help in figuring out what exactly do i need form hardwareperspective to make following setup:
Currently, I have:
4 Single LNB's pointing to 4 different satellites
1 4-Way Diseq splitter (Used as multiswitch in ProgDVB)
1 Coax cable
1 USB DvbSky receiver
All 4 satellites work OK and I'm happy with everything.
Now I need help to identify the hardware to extend this setup to TWO recievers over the same cable. I was looking everywhere but I cannot understand what hardware I need to make this happen. Only what i found was that is possible and than answers go on limitations that I am fully aware of. but no "How to" is to be found with 100% certanty it will work.
I do not care about the costs, just need to know the logic and what hardware I need to make this single cable distribution.
If anything, where should I post this question as I can't find a good Satellilte forum anywhere
Thanks!
Re: 4 Single LNB's on two recievers at the same time
#3Hi,
thanks!
This would mean I would need to exchange all of my single LNB's with quattro LNB's, connect each of the LNB's outputs to appropriate multiswitch inputs. This is clear, I need 16 inputs on multiswitch.
However, how do I get them to distribute to only one coax and split the coax to two recievers afterwards?
This is where I do not understand the logic
thanks!
This would mean I would need to exchange all of my single LNB's with quattro LNB's, connect each of the LNB's outputs to appropriate multiswitch inputs. This is clear, I need 16 inputs on multiswitch.
However, how do I get them to distribute to only one coax and split the coax to two recievers afterwards?
This is where I do not understand the logic
Re: 4 Single LNB's on two recievers at the same time
#4If you not need signal for both receivers in same time then any splinter if good for you.
Re: 4 Single LNB's on two recievers at the same time
#5Hi,
yes, I do want signal from both recievers at the same time with all LNB's available.
This is why I find this so hard to understand what I need.
yes, I do want signal from both recievers at the same time with all LNB's available.
This is why I find this so hard to understand what I need.
Re: 4 Single LNB's on two recievers at the same time
#6Then you need 4 quad LNBs. Every universal LNB can working only in one of 4 bands in same time.