#2
by Juergen
No way to tell.
As the manufacturer is not specified, nor is the full model name, that case may contain anything...
You're going the wrong way. First look for manufacturer or distributor pages with relevant details, then think about shops and sellers.
However, there is a good chance, that device uses BDA drivers. If so, it could supposingly be used in ProgDVB, after the original software and driver package is installed and set up completely. But in many cases DiSEqC would not work then. Same goes for the remote, if it's not available system wide as a MS HID.
BTW, ebay links are getting useless after some time.
And as they are extremely long, they break our page layout.
And they may occasionally even include some private data...
Last idea, 'cheaper' should not be the only aspect for a bargain...
My signature:
Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!
I don't give support by e-mail or PM.
And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!
NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.
Please keep it in English here, or Russian in the Russian section, or German in the German section.
I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!
1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode
19.2°,13°,28.x°E,30°W, DiSEqC 1.0
Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>
