Hi all.
I use a registered (bought….) Progdvb pro latest edition, and I have a rather anoying bug with OSD.
As long as I open the OSD, the picture (mostly the hole program ), acts like lossing frames.Even the mouse motion is interupted.
I had a look @ happysat but I haven’t found anything helpful.

This is my configuration (in case it helps):

Motherboard: ASUS M3A78-EMH HDMI (Ati HD3200 on board VGA)
Cpu: AMD ATHLON 64 X2 4800+ 2.50GZ AM2 BOX
Memory: TRANSCEND JM667QLU-2G DDR2 2GB PC5300 667MHZ
DVB-S card: Skystar2

I use Windows Xp with latest patches/drivers.

You can change video render in settings->Options->Direct show.

Thanks for the Quick reply.

I 've used also the VMR9 render with the same results.
Something i haven't done (and will do @ evening) is to make a clear install of the new version.I found out by installing the latest version @ an other pc, that the enhanced rendering engine is working ok (which is grayed out at the installation on my Media center PC mentioned above) .Maybe i have some problems caused by the upgrade procedure i used to do (just installing the latest version over the old isntallation).
I will post the results.....

You must install net 3.5 for EVR

Thanks alot Prog.
By installing the .Net 3.5 i was able to use the enhanced rendering engine.
Things got alot better now. With the OSD on screen the video behind is flawless.Only when i move at the OSD channel list i see some interruptions .
Although the above is good now i couldn't give a try at a clean install. The behavior is the same so it is not an issue concerning the upgrade procedure.

Look into your codec's properties.
Some of those come with a bunch of settings, that can make them behave fat, slow and greedy...