Hi, I use ProgDVB Pro 6.32.06 with two TV-cards Satelco easywatch dvb-c with BDA driver.
PIP works fine. But I had to scan channels for each card and now each channel is shown twice in the channel list: I select the first channel. Then I select the second channel, but I have to select it for the other card. If I select this channel for the same card I cannot "open in new window" (it's grayed out).
Is it possible to have each channel only once in the list and to open another channel in a new window (and ProgDVB selects the other card automatically)?
Many thanks!
Gottfried
Re: .
#3Hi, thanks for the reply.
I have tried it, but it is not possible to click it if it is grayed out.
The channel search is quite strange:
When I did it for the first time about 200 channels have been found. Then I did a search on the second card, but no channels have been added. All channels have been bound to the first card. It was not possible to "open in new window".
I created a new channel list, copied all channels to it and tried to change the properties of one channel to the second card. After that most of the channels were gone, only a few remained - in both channel lists!
I deleted the new channel list and deleted all channels from the first channel list ("all channels"). I did a channel search: During search I saw that many channels were found (good level and quality), but when the channel search was done the window "new channels" was empty. No channels have been added, the channel list was still empty!
I had to close ProgDVB and deleted all files in folder "channels". Then I restarted ProgDVB and could start a channel search, channels were added to the channel list.
I suggest that after channel search you get a window to save the found channels to a file and that you can load a new created channel list from a file.
best regards
Gottfried
I have tried it, but it is not possible to click it if it is grayed out.
The channel search is quite strange:
When I did it for the first time about 200 channels have been found. Then I did a search on the second card, but no channels have been added. All channels have been bound to the first card. It was not possible to "open in new window".
I created a new channel list, copied all channels to it and tried to change the properties of one channel to the second card. After that most of the channels were gone, only a few remained - in both channel lists!
I deleted the new channel list and deleted all channels from the first channel list ("all channels"). I did a channel search: During search I saw that many channels were found (good level and quality), but when the channel search was done the window "new channels" was empty. No channels have been added, the channel list was still empty!
I had to close ProgDVB and deleted all files in folder "channels". Then I restarted ProgDVB and could start a channel search, channels were added to the channel list.
I suggest that after channel search you get a window to save the found channels to a file and that you can load a new created channel list from a file.
best regards
Gottfried