Re: Lifeview NotonlyTV LV83ATS & positioner

#4
Drivers can only be made or changed by manufacturers.

DiSEqC 1.1 and 1.2 or USALS are all followers of 1.0, not of each other. Full technical specifications of DiSEqC can be obtained for free from Eutelsat.

But this does not help here, as in fact we don't know, if it's (driver) code or firmware code or perhaps plain hardware limitation in your case.
AFAIK lifeview dont provide a SDK for your tuner, that could possibly give Prog a hint.

So, as Prog told, try Microsoft mode in Settings->Device options. Else forget about it...
My signature:

Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!



I don't give support by e-mail or PM.

And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!

NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.

Please keep it in English here, or Russian in the Russian section, or German in the German section.

I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!


1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode

19.2°,13°,28.x°E,30°W, DiSEqC 1.0


Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>
cron