#2
by Juergen
As you're using a Nexus 2.3, try another (DiSEqC 1.2 compatible) software for it and compare.
And / or test with a suitable receiver, if any possible.
(Modern versions of) ProgDVB should be able to use DiSEqC 1.2 on your card without any plugin. Look into the device list, mark the SS1, read features support list.
No idea, how positions are stored in / for your motor.
Get hold of all documentation you can get for it and read.
Only an owner of such a hardware config like yours would perhaps be able, to write some manual for it. I don't move my dishes, use multifeed instead. AFAIK Prog and SiLencer also don't use motors.
My signature:
Please read here:
On Bug Reports And Other Complaints
and there:
BOARD RULES - READ THIS!
I don't give support by e-mail or PM.
And I will never assist on PayTV hacking.
PM ME FOR THIS AND YOUR ACCOUNT WILL BE DELETED IMMEDIATELY, WITHOUT ANY WARNING!!!
NEVER EVER DARE TO CONTACT ME FOR PRO VERSION ISSUES!
I am not responsible for that.
Check the 'Activation' section.
Please keep it in English here, or Russian in the Russian section, or German in the German section.
I don't read nor write Klingonian or any other language than English and German.
Addressing me personally in any exotic language will be treated as severe insulting! Be warned!!!
1.)AMD Phenom II x4 940, GA-MA770-UD3, 8 GB DDR2-6400. 7 Pro SP1 x64 + XP Pro SP3 x86
DVB-S2: Cynergy S2 USB HD
2.)P4 3200 i865G (F-S Scenic W600pwr) XP Pro SP3
DVB-S: hauppauge WinTV Nexus-S rev. 2.2, driver TT 2.19h, hardware mode
19.2°,13°,28.x°E,30°W, DiSEqC 1.0
Auf Deutsch:
DVB-Cube <<< Das deutsche DVB-Forum >>>
